Cabela's Adventure 5500 Manual de usuario Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 11
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
16
In The Field Techniques
When pinpointing a target, try drawing an “X”,
as illustrated, over where the tone is induced.
PINPOINTING
Accurate pinpointing takes practice and is best
accomplished by “X-ing” the target area.
1. Once a buried target is indicated by a good
tone response, continue sweeping the coil
over the target in a narrowing side-to-side
pattern.
2. Take visual note of the place on the ground
where the “beep” sounds.
3. Stop the coil directly over this spot on the
ground.
4. Now move the coil straight forward and
straight back towards you a couple of times.
5. Again make visual note of the spot on the
ground at which the “beep” sounds.
6. If needed, “X” the target at different angles
to “zero in” on the exact spot on the ground
at which the “beep” sounds.
COIL MOVEMENT
When swinging the coil, be careful to keep it
level with the ground about 2.5cm (1 inch)
from the surface. Never swing the coil like a
pendulum.
CORRECT
WRONG
5
Assembly
Adjusting the Arm Rest
Most people will find the standard position of the arm rest
very comfortable. Very large forearms and short forearms
(particularly children’s arms), can be accommodated by
moving the arm rest forward.
The arm rest is adjustable to three positions.
To adjust, remove the screw from the underside, then
press the silver button and move the arm rest to one of
the alternate positions. If you cannot fully depress the
button with your finger, use a narrow object, such as the
blunt end of a ballpoint pen. The arm rest must be
twisted with moderate force to move it to an alternate
position; this adjustment is usually made infrequently.
If desired for added stability, re-install
the screw. The screw is not re-installed
in the furthest forward position.
If the button becomes disengaged
inside of the tube, remove the plastic
cap at the end of the tube to access the
clip inside. With a pair of needle-nose
pliers, reengage the button. Then
replace the plastic cap.
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios